Problem 2 — Transient of RL network (15 pts) An inductor L=50 mH, resistor R=10 Ω, and a 5 V step source are connected in series. At t=0 switch closes. a) (7 pts) Derive i(t) for t≥0. b) (4 pts) Compute the energy stored in the inductor at t = τ (one time constant). c) (4 pts) Numerically evaluate i(t) and stored energy at t=τ. (Show numeric τ.)

Part C — Design, analysis & applications (50 pts) Problem 7 — Filter synthesis & Bode (20 pts) Design a second-order Butterworth low-pass filter with cutoff fc = 1 kHz using an active Sallen–Key topology with unity gain buffer. Use standard component values within a factor of two. a) (6 pts) Provide component values (R1, R2, C1, C2) and show normalized component selection for Butterworth (Q=0.707). b) (6 pts) Derive the transfer function H(s) and show the -3 dB cutoff condition. c) (8 pts) Sketch (or describe numerically) magnitude Bode plot points at 10 Hz, 100 Hz, 1 kHz, 10 kHz, and 100 kHz (provide gains in dB).

Part D — Essay & synthesis (20 pts) Choose one of the two prompts (answer thoroughly, ~300–500 words):

Problem 9 — Practical measurement & instrumentation (15 pts) You must measure a small AC voltage (peak 20 mV) in presence of large common-mode interference (~10 V) using an instrumentation amplifier built from op-amps. a) (6 pts) Sketch the schematic conceptually (describe stages: input filtering, INA, gain, common-mode rejection). b) (5 pts) Choose an INA gain to get ~2 V full-scale output and compute resistor values or gain-setting component. c) (4 pts) List three practical techniques to maximize CMRR and reduce noise in this measurement.

Prompt A — Innovation case: Propose a compact, low-cost power-supply module for a battery-powered sensor node requiring 3.3 V at 100 mA from a 3.7 V Li-ion cell. Include topology choice, efficiency considerations, thermal constraints, component selection rationale, and brief EMI mitigation strategies.